Code No.U0170 Left front impact sensor communication error







caution |
If the diagnosis code U0170 is set to SRS-ECU, be sure to diagnose the CAN bus line.
|
|
If an impact of set value or more is detected, the front impact sensor sends the coded acceleration data to SRS-ECU. Based on the acceleration data, SRS-ECU determines the necessity of driver’s and passenger’s (front) air bag, knee air bag and pre-tensioner deployment, and then turns ON the power supply circuit to the inflator.
|
|
The code is set if the communication between the left front impact sensor and SRS-ECU is abnormal.
|
|
- Malfunction of left front impact sensor
- Damaged wiring harness and connectors
- Malfunction of SRS-ECU
|
|
STEP 1. M.U.T.-III CAN bus diagnostics.
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
|
|
|
|
STEP 2. Check whether the diagnosis code is reset.
|
|
(1)Connect the negative battery terminal.
|
|
(2)After erasing the diagnosis code memory, check the diagnosis code again.
|
|
(3)Disconnect the negative battery terminal.
|
|
Q.
Is the diagnosis code No. U0170 set?
|
|
Go to Step 3.
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|
STEP 3. Left front impact sensor check.
|
|
(1)Check that the negative battery terminal is disconnected. If the negative battery terminal is connected, disconnect it.
|
|
(2)Alternate the right front impact sensor and left front impact sensor, and then install the alternated sensors.
|
|
(3)Connect the negative battery terminal.
|
|
(4)After erasing the diagnosis code memory, check the diagnosis code again.
|
|
(5)Disconnect the negative battery terminal.
|
|
Q.
Is the diagnosis code No. U0171 set?
|
|
Replace the left front impact sensor (Refer to ).
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Wiring harness check between the A-43 left front impact sensor connector terminal No. 1/2 and the C-122 SRS-ECU connector terminal No. 22/21.
|
|
note |
Prior to the wiring harness inspection, check the A-37, C-128 intermediate connector, and repair if necessary.
|
|
|
- Wiring harness check for open and short circuit between left front impact sensor and SRS-ECU
|
|
Q.
Is the check result normal?
|
|
Go to Step 5.
|
|
|
|
Repair the wiring harness.
|
|
|
|
STEP 5. Check whether the diagnosis code is reset.
|
|
Q.
Is the diagnosis code No. U0170 set?
|
|
Replace SRS-ECU (Refer to ).
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
faq.Lancer-Club.ru