DIAGNOSIS PROCEDURE |
STEP 1. M.U.T.-III CAN bus diagnostics |
Use M.U.T.-III to perform the CAN bus diagnosis. |
Q.
Is the check result normal?
|
Go to Step 2. |
|
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnosis Table ). |
|
STEP 2. M.U.T.-III data list |
Item 19: Stop lamp switch (Refer to Data List Table ). |
Q.
Is the check result normal?
|
Go to Step 3. |
|
Stop lamp switch system check (Refer to GROUP 35B, Troubleshooting - Diagnosis Code Chart ). |
|
STEP 3. Symptom recheck after erasing diagnosis code |
Q.
Is the check result normal?
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ). |
|
Replace A/T-ECU. |
|